Foscam C1 Lite User Manual page 12

Now, you could use your camera in LAN.
Note:
64-bit browser is not supported.
2.2.2 WPS (WI-FI Protected Set-up)
Before using WPS wireless connection, you need to:
Make sure that your wireless router has the WPS function.

WPS button on the wireless router is typically located on the front panel or rear panel.TP-LINK

router's WPS button is called QSS (Quick Security Setup).
Make sure that the ethernet cable and the camera is disconnected.

(1) Press and hold the WPS button for three seconds. The Network light of the camera begins to twinkle
at high frequency. (every 0.4 seconds)
(2) Press and hold the WPS button for three seconds on your wireless router within 60 seconds. Then
the camera will automatically create a secure wireless connection to your router in about 60
Main stream offers the
highest quality video while
Sub stream offers less
quality, but also less delay
when viewing.
10
WPS Button