System Configuration Procedure - Netafim NMC-PRO Installation Manual

ELECTRICAL INSTALLATION
4.6.4.2 Manual Test
Manual testing enable you to verify that valves open in response to an electrical current.
1. Go to Test > Analog Output.
2. The screen displays the following:
3. Place the cursor on the valve requiring testing, press Enter and select.
4. Under Open%, enter an opening percentage.
Pro sends an electrical current to the valve, based on the number entered.

 If the valve opens, OFF appears under Fail. If the valve does not open, ON appears.

4.7 System Configuration Procedure

• Device Delay Configuration, page 47
• Pump Station Configuration, page 48
• Valve Configuration, page 48
• Valve Flow Rate Configuration, page 48
• Water Meter Configuration, page 49
• Dosing Configuration, page 50
• EC/PH Sensor Range, page 51
NMC-PRO Installation Manual
Page 46