Output Terminal; Analog Output Card - Netafim NMC-PRO Installation Manual

ELECTRICAL INSTALLATION

4.2 Output Terminal

• Analog Output Card

• 24 VAC Connection
• Dry Contact Card
4.2.1 Analog Output Card
• Analog Output Card Installation
• Analog Output Card Setup
4.2.1.1 Analog Output Card Installation
1. Verify the following before installing the cards:
 NMC Pro Controller firmware is Version 3.7.02 or above
 NMC Net Version: 4.07.18
NMC Air: NMC Air does not support NMC PRO Ver 3.7.02. Netafim will notify you when an updated

version of NMC AIR is available.
2. Disconnect the controller from the power.
3. Install the analog cards in the slots indicated in I/O Card Layout, page 19.
4. Apply power; the NMC Pro will detect the new card(s).
5. In the screen that appears, select YES.
6. Go to the Installation Menu to confirm that the card is installed.
NMC-PRO Installation Manual
Page 21