Fm Radio - Scansonic R110 Owner's Manual

R110

FM radio

FM radio mode receives analogue radio from the FM band.
To enter FM mode, press Mode until the display shows FM radio
or press FM on the remote control.
Selecting stations
To find a station, press Select. The frequency display to count as the unit scans the FM band.
Alternatively, you can scan up or down by pressing the Up or Down button or press and hold
the l>> or <<l on the remote control.
Presets
To store a station as a preset, press and hold Preset until the display shows the Save to preset
screen. Select one of the 10. presets and press Select to save.
To select a preset, press Preset briefly, then select one of the listed presets.
Scan settings
By default, FM scans stops at any availble station. This may result in a poor signal to noise ratio
(hiss) from weak stations.
To change the scan settings to stop only at stations with good signal strength, select
Menu > Scan setting and change option to Yes
Audio settings
By default, all stereo stations are reproduced in stereo. For weak stations this may result
in a poor signal to noise ratio (hiss).
To play weak stations in mono, select Menu > Audio setting and change option to YES.
10