Additional Information; Using A Wall-Mount Bracket; Detaching The Table-Top Stand From The - Sony BRAVIA KDL-48W655D Operating Instructions Manual

Additional Information

Using a Wall-Mount Bracket

This TV's instruction manual only shows the
steps on preparing the installation of the TV
before installing to the wall.
Your TV can be mounted on a wall using a Wall-
Mount Bracket (not supplied) out of the box as
packaged. If the Table-Top Stand is attached to
the TV, the TV may require detaching the Table-
Top Stand; see page 40 (Detaching the Table-
Top Stand from the TV).
Prepare the TV for the Wall-Mount Bracket
before making cable connections.
For product protection and safety reasons,
Sony strongly recommends that installation
of your TV on the wall be performed by
qualified professionals. Do not attempt to
install it yourself.

Follow the instruction guide provided with the
Wall-Mount Bracket for your model. Sufficient
expertise is required in installing this TV,
especially to determine the strength of the
wall for withstanding the TV's weight.
 The length of the screw for Wall-Mount
Bracket differs depending on the Wall-Mount
Bracket thickness. Please see below
illustration.
10 mm - 12 mm
Screw (supplied with the
Wall-Mount Bracket)
Wall-Mount Bracket

Be sure to store the unused screws and Table-
Top Stand in a safe place until you are ready to
attach the Table-Top Stand. Keep the screws
away from small children.
Note
• Read the supplied Safety Booklet for additional safety
information.
40
US

Detaching the Table-Top Stand from the

TV
To detach the Table-Top Stand from the TV,
remove the screws.
Note
• Do not remove the Table-Top Stand for any reason
other than to install corresponding accessories on the
TV.
• When removing the Table-Top Stand from the TV, lay
the display face down on a stable work surface that is
larger than the TV.
• To prevent damaging the surface of the LCD display,
make sure to place a soft cloth on the work surface.
• Be sure the TV is vertical before turning on. To avoid
uneven picture uniformity do not power on the TV
with the LCD panel facing down.
• When attaching the Table-Top Stand again, be sure to
fasten the screws (previously removed) to the original
holes on the rear of the TV.