NEC Express5800/R110i-1 Maintenance Manual page 206

Chapter 3 Appendix
Windows Server 2012 R2
System Log
Microsoft-Windows-
Kernel-EventTracing
2
When running an OS for the first time
b57nd60a
4
When installing an OS, starting system,
or applying Starter Pack
l2nd
4
When installing an OS, starting system,
or applying Starter Pack
Megasas
11
When applying Starter Pack
ixgbs
27
When starting system or installing
Starter Pack
volmgr
46
When installing an OS
Megasas35
129
While the system is running
Microsoft-Windows-
Time-Service
134
When installing an OS, starting system,
applying Starter Pack
disk
153
When creating logical drive by Universal
RAID Utility
206
The session "" could not be started due to the following error:
Error
0xC000000D
This event does not affect system operation.
Broadcom NetXtreme Gigabit Ethernet #xx: The network link is down.
Warning
Check to make sure the network cable is properly connected.
This event does not affect system operation.
QLogic BCM57810 10 Gigabit Ethernet (NDIS VBD Client) #xx:
Warning The network link is down.
Check to make sure the network cable is properly connected.
This event does not affect system operation.
Error The driver detected a controller error on \Device\RaidPort(x).
This event does not affect system operation if it is logged when applying
Starter Pack.
Intel(R) Ethernet Controller X550 #xx
Warning
Network link is disconnected.
This event does not affect system operation.
Error Crash dump was not initialized.
Refer to the following website.
http://support.microsoft.com/kb/2756313
Reset command is issued to device \Device\RaidPort(x).
Warning
(Any number replaces x)
This event does not affect system operation. If this message is logged
because OS has succeeded retry process.
The manual peer that is used as the time source in NtpClient could not
Warning be set due to DNS resolution error at "time.windows.com,0x9". Retry
after 15 minutes and, after that, retry at double intervals.
If it is not registered after connection with the Internet, there is no
problem for system operation.
The I/O operation at the logical block address for disk was retried.

The on-screen indication may differ depending on system
Warning environment.

The character string of this event may not be displayed correctly,
however, it does not affect the system operation.
If this event is logged when creating a logical drive by Universal RAID
Utility, there is no problem in system operation.
The character string of the event will be correctly displayed by applying
the Microsoft's update program on the following site:
http://support.microsoft.com/kb/2925479
Express5800/R110i-1, T110i-S, T110i Maintenance Guide
2. List of Windows Event Logs