Drill Master 500X User Manual page 33

Reversing or Replacing Your Diamond
Sharpening Wheel
www.drilldoctor.com
1. Unplug your Drill Doctor, make
sure machine is cool, then remove
wheel access cover.
2. Use wrench supplied with your
Drill Doctor to hold sharpening
wheel in place.
3. With #3 Phillips head screwdriver,
remove one left-handed screw
(clockwise to loosen) and remove
the wheel retainer.
4. Remove worn wheel by twisting
slightly and lifting wheel off shaft.
Install new wheel and reinstall
wheel retainer and screw. Don't
over-tighten
(tighten to about 48 in/lbs).
Remove the wrench and replace
the Wheel Access Cover before
turning on the machine.
mounting screw
33