Drill Master 500X User Manual page 18

Alignment Button
118°
Drill Bit
Stop
18
2. Insert Chuck into
Alignment Port
Press the Alignment Button down
that opens the bit clamp arms.
Insert either of the Alignment
Guides (raised fins) on the Chuck
into the 118° notch on the
Alignment Port. With the clamp
arms held open, slide the drill
bit forward until it touches the
Alignment
Guide
Drill Stop. (Make sure the Chuck
is seated all the way into the
Alignment Port). Now release the
Alignment Button, releasing the
clamp arms.
When sharpening standard 118°
drill bits, align in the 118° slot.
For standard 135° drill bits, align
1-notch to the right (-) of the 118°
slot.
3. Adjust Bit Position
Check to ensure your bit is held in
place correctly. The Clamp Arms
should be holding the drill bit at
its narrowest spot (in the flutes).
If they aren't, turn the bit slightly
until they fall into the flutes. This
is an important step to proper
alignment.
Drill Bit Stop
Bit Clamp Arms
www.drilldoctor.com