Drill Master 500X User Manual page 20

Different size drill bits may require a different number of rotations.
Continue to sharpen until you no longer hear grinding noise. This
will result in a Chisel Edge that is clean and straight and ensure the
entire surface from the Cutting Edge to the Heel is finely ground.
Note:
If splitting your drill bit, do not remove from Chuck after
sharpening.
20
1. Sharpening Guides
Insert Chuck into Sharpening Port
with either of the Sharpening Guides
(white lines) lined up with the Cam Pin
2. Sharpen Your Bit
Rotate Chuck in a clockwise direction
(from white line to white line) until
there is no more grinding noise. Ensure
you are keeping Chuck up against Cam
Pin at all times. Your motion should be
smooth and even.
on the machine.
Cam
Sharpening Guide
(white lines)
Cam Pin
www.drilldoctor.com