Using The Selfie Stick; Connecting The Selfie Stick And Smartphone/ Compact Camera Via Bluetooth - Silvercrest SSP 2600 A1 Operating Instructions Manual

♦ During the charging process, the current charge
level of the power bank is shown via the charge
level LEDs
charge level").
♦ To stop charging, disconnect the charging cable
from the mobile device and the power bank.
The charging status LEDs
30 seconds.
Using the selfie stick
Before you use the selfie stick, you must first pair it with
your smartphone or compact camera via Bluetooth
This pairing creates a link between your smartphone or
your compact camera and the selfie stick.
NOTE
► Make sure that the battery of the power bank is
charged; otherwise the selfie stick will not work.
If necessary, charge the power bank battery
before using the selfie stick. Refer also to section
"Charging the power bank".
Connecting the selfie stick and smart-
phone/compact camera via Bluetooth
♦ Turn on your smartphone or compact camera and
activate the Bluetooth
♦ Press and hold the On/Off button
2 seconds to activate the Bluetooth
The Bluetooth
7 seconds and then flashes for one minute. The
charging status LEDs
after about 30 seconds.
♦ Set the smartphone so that it scans for Bluetooth
devices. You will find a detailed description of
how to do this in the operating instructions for your
smartphone.
♦ Select SSP 2600 A1 from the list of found devices
on your smartphone to pair the two devices. The
Bluetooth
is successful.
SSP 2600 A1
(see table in section "Checking the
®
LED
®
light up and then go off
LED stops flashing when pairing
®
go off after about
function.
for about
®
lights up for approx.
GB │ IE │ NI
.
®
®
function.
®
9 ■
│