Checking The Charge Level; Handling And Use; Charging Mobile Devices With The Power Bank - Silvercrest SSP 2600 A1 Operating Instructions Manual

LED display
One LED is flashing
One LED is on, the second
LED is flashing
Two LEDs are on, the third
LED is flashing
Three LEDs are on, the fourth
LED is flashing
All LEDs are on

Checking the charge level

You can also check the charge level of the power
bank when it is not charged or while it is being used
for charging.
♦ Press the on/of button
status LEDs
power bank for about 30 seconds.
LED display
Four LEDs are on
Three LEDs are on
Two LEDs are on
One LED is on
One LED is flashing

Handling and use

Charging mobile devices with the
power bank
♦ Connect the micro-USB plug of the charging cable
to the micro-USB port of the mobile device you want
to charge and the USB plug to the USB port
on the power bank. The charging process starts
automatically.
♦ If charging does not start automatically, press the
On/Off button
process.
NOTE
► Alternatively, you can also use the original charg-
ing cable (USB cable) provided by the respective
device manufacturer.
│ GB │ IE │ NI
■ 8
briefly. The charging
show the current charge level of the
briefly to start the charging
Charge level
Less than 20%
20–49%
50–74%
75–99%
100%
Charge level
More than 75%
50–74%
25–49%
3–24%
Less than 3%
SSP 2600 A1