Table of Contents
Advertisement
www.seagate.com
Chapter 2: Installation
2.1
Quick Installation Instructions
You can use the quick installation instructions to install your Nytro WarpDrive card, or you can see the next section if
you need more detailed installation instructions.
To quickly install your Nytro WarpDrive card, follow these instructions.
1.
Unpack the Nytro WarpDrive card and inspect it for damage.
2.
Turn off the server, and remove the power cord.
3.
Remove the cover from the server.
4.
Insert the card in an available PCIe slot.
5.
Secure the bracket to the system's chassis.
6.
Replace the cover and the power cord, then turn on the server.
The Nytro WarpDrive card hardware installation is complete.
2.2
Hardware Installation Instructions
2.2.1
Card Retention, Shipping, and the PCIe Specification
The PCIe specification requires that add-in cards with a mass of greater than 350 grams must have additional card
retention at the server level. Neither the connector nor the optional hockey stick feature described in the PCIe
specification provides the required retention.
Server OEMs and ODMs are solely responsible for choosing and qualifying their own server and rack shipping
solution. Seagate does not qualify the server and rack shipping solution and is not responsible for such solution or any
impact to Seagate products.
Seagate will make available mechanical design collateral for its products, which may be used by server OEMs and
ODMs to design retention features for their server products. Seagate information is provided AS IS only and Seagate
does not certify any design retention features used by OEMs and ODMs.
Seagate does not perform server and rack shock and vibration testing of OEM and ODM products. OEMs and ODMs
are solely responsible for any server and rack shock and vibration testing.
2.2.2
Hardware Installation for the Nytro WarpDrive 6203, Nytro XP6209, Nytro XP6210 Cards
1.
Unpack the Nytro WarpDrive card and inspect it for damage. Unpack the card in a static-free environment and
follow good antistatic grounding procedures. Remove the Nytro WarpDrive card from the antistatic bag, and
carefully inspect it for damage. If you notice any damage, contact Seagate, or your reseller support representative.
2.
Prepare the computer. Turn off the server, and disconnect the power cords from the power supply. Remove the
cover from the chassis.
Seagate Nytro WarpDrive and Nytro XP6000, Rev. 1.12
NOTE
Back up your data before changing your system configuration.
WARNING
To avoid electrical shock, disconnect the server from the main power
and from any networks before you install the card.
Quick Installation Instructions
8
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
