Connect Power And Setup Dmx - MAGIC FX SMOKEBUBBLE BLASTER MFX1603 User And Installation Manual

3.6

CONNECT POWER AND SETUP DMX

1. Connect a power cable with a Powercon TRUE1 Female connector to the power input.
2. Connect the other end of the power cable to a 220 - 240 Vac (50-60Hz) power source.
3. Connect the female connector of a 5-pole DMX cable in the DMX input.
4. Connect the other end of the DMX cable to your DMX controller.
5. Switch the machine ON (If Manual mode is ON, the machine starts bubbling instantly).
6. Make sure that in the menu Manual mode is OFF, see Section 1.7.
7. Use the display and buttons or a RDM controller to assign DMX addresses, see Chapter 1.
8. Optionally see Section 3.7 for adding more machines to the same sequence.
Always plug in a DMX Terminator into the DMX output. Using a DMX Terminator
CAUTION
improves signal reliability.
5-pole female
DMX
PowerCon TRUE1 female
POWER
MAGICFX® SMOKEBUBBLE BLASTER — User and Installation Manual 25