Digital Equipment VAXstation 2000 Owner's Manual page 73

The verifier takes 5 minutes for an RD32 fixed disk drive, 8 minutes for an
RD53, and 20 minutes for an RD54.
r^\ Note: The fixed disk verifier does not destroy software or data on the
disk.
Note: Read your software documentation for shutdown procedures before
halting the system.
1. Put the VAXstation 2000 in console mode by pressing the halt button on
the rear of the system unit.
2. Type TEST 71 at the console prompt (»>), then press Return.
The following text is displayed:
VSmsv_QUE_unitiio (0-1)?
3. Type 0 to verify a fixed disk drive in the system unit or 1 to verify a
fixed disk in the expansion box, then press Return.
The following text is displayed:
VSmsv_STS_Siz RDxx [xx represents 32. 53, or 54 depending
^ on the type of fixed disk drive.]
VSmsv_QUE_RUsure (DUAx 1/0) ? [x represents the number
chosen, 0 or 1.]
If the disk has not been formatted or a problem occurs vdth the disk, the
following text appears:
VSmsv.STS.Siz ??
VSmsv_RES_Err #2
84 FAIL
» >
If you see this text and you want to format your disk, format it according
to the instructions in Chapter 1. If the disk is faulty, the formatter
program will not be able to complete the formatting procedure. If this
happens, call your service representative.
^ 4. Type 1 and press Return if you want to continue. To stop the verifier,
type anything other than 1. The verifier stops, an error message is
displayed, and the console prompt (»>) is returned. You may start over
with the TEST 71 command or any other command.
The following sample text is displayed after you type 1:
Troubleshooting 2-21