Troubleshooting - Rowenta Master DG 560 Instructions For Use Manual

Always remember:
Battery water and water containing additives (such as starch,
perfume or fabric conditioner) may not be used. Such
additives can affect the properties of the steam and, at high
temperatures, can form deposits in the steam chamber, which
will mark the laundry when they are emitted through the
steam vents. Descaling liquids/agents should not be used.

TROUBLESHOOTING

Issues
Water runs
through the
holes in the
soleplate.
White streaks The boiler has a build- Rinse the boiler after
come through up of scale and needs
the holes in
the soleplate. regularly.
Brown streaks Chemical descaling
come through agents or additives
the holes in
the soleplate.
The soleplate Ironing at too high a
has build-up. temperature.
There is little The boiler is empty.
or no steam. The boiler is not
Steam escapes Cap screwed on
from the
boiler cap.
If troubleshooting does not assist, before consulting the
retailer regarding their return/exchange policy, please
telephone consumer service at 781-396-0600.
Possible causes
Boiler is too full.
Thermostat isn't
working.
The iron was used
before it had reached
temperatures.
Water has condensed
in the steam tube as
iron hasn't been used
for some time.
DG 580
Steam output control
dial is set too high
for the temperature
set on the iron.
to be rinsed out
have been used.
Tap water is high in
organic matter such
as rust or iron.
Spray starch
build-up.
ready.
incorrectly.
The seal on the cap
is worn.
Solutions
Do not fill the boiler
with more than 33oz
water.
Send appliance to an
authorized service
center.
Wait for the tempe-
rature/steam control
lights to go out
before ironing.
Press the steam
control button away
from your clothes
until iron produces
steam.
DG 580
Decrease steam out-
put while ironing at
low temperature ( ).
every 10 uses (see
Cleaning and Main-
tenance section).
Never use descaling
agents or additives.
Rinse boiler
thoroughly.
Switch to bottled
spring water or rinse
boiler more often.
Refer to the Steam
Ironing section of the
instructions for
temperature
recommendations.
Spray starch on the
reverse side of the
garment.
Fill the boiler.
Wait for the steam
indicator light to go
out before using
steam.
Unscrew cap when
unit is cold and put
back on.
Check cap regularly
for signs of wear and
tear to red rubber
ring. Replace if wear
is noticed.