Troubleshooting - Rowenta DZ2060 Manual

1103901474 DZ2060 Actisteam US
• To prevent scratching of the soleplate, do not iron over sharp
objects (zippers, etc.). Do not place the iron on rough surfaces ,
e.g. metal iron support, which may scratch the soleplate.

Troubleshooting

Issues
Iron does not
heat.
Not enough
steam.
Iron is emitting a
brown or white
substance.
Iron is leaking.
Build up on the
soleplate.
Spray function
does not work.
If you are unable to trace the cause of the fault, contact an official
Rowenta Customer Service Center.
Further hints and tips visit:
www.rowentausa.com
22/10/07
Possible causes
Not properly plugged
in.
The temperature
control is set too low.
There is insufficient
water in the tank.
Iron is not set to a
steam setting.
The Anti-drip function
is active, depending on
model.
Water may need to be
changed due to hard-
ness or organic matter.
Garment has not been
rinsed sufficiently.
Over use of burst
button.
Distilled or softened
water being used.
Overfilled.
Starch use.
Burnt material.
Ironing at too high
temperature.
Priming may be
necessary on first use.
9
10:09 Page 9
Solutions
Check that iron is plugged
correctly.
Set the temperature control to a
higher temperature.
Fill the water tank.
See section called "Steam
Ironing".
Wait for the soleplate to reach
the correct temperature.
See section "Water recommenda-
tions". Switch to spring water or
mix tap water with distilled water.
Ensure garments are rinsed
thoroughly to remove any
detergent desposits or chemicals
on new garments.
Allow more time between each
burst.
See section "Water recommenda-
tions". Switch to spring water or
mix tap water with distilled water.
Do not fill past max line on tank.
Be sure to close the cover at
filling inlet, depending on model.
Spray reverse side of fabric and
allow starch to penetrate.
Be sure to set temperature
according to fabric being ironed.
Fill with water.
Hold cold iron horizontally.
Place finger over the spray
nozzle to create a vacuum.
Press the spray button 4 to 5
times.
Remove finger from nozzle,
press spray button a few more
times.