Verify Lamp Settings - EFI Pro 24f Operation Manual

6.1.2 Verify Lamp Settings

1. On the EFI PLC Control window (see Section 4.3.10), in the LED Lamps box, verify that the cure lamps are on by checking that
the light bulb icons are yellow.
2. Click any light bulb that isn't yellow, to toggle it to yellow/on.
3. In the toolbar at the bottom of the EFI Pro 24f Control window, choose the Controls/Ink button to open the EFI PLC Control win-
dow.
4. On the EFI PLC Control window, in the Light Power box, verify or set the lamp intensity at 100%.
Document ID: OMM-00148 Rev. B
Figure 6-2: EFI PLC Control Window - LED Lamps Box
Figure 6-3: EFI Pro 24f Control Window - Controls/Ink Button
Figure 6-4: Light Power Settings
59