CTC Union FRM220-1000E-1 User Manual

Introduction
The FRM220-1000E(S)-1 is a copper to fiber Gigabit Ethernet
solution designed to make conversion between 10/100/1000
Base-TX and 1000Base-SX/LX with SC or SFP LC connector.
With SNMP and Web-based management in the FRM220, the
Network administrator can monitor, configure and control the
activity of each card in the chassis. This converter also supports
features such as ingress/egress bandwidth control, auto or forced
mode setting for copper Ethernet as well as auto laser shutdown.
Features
Network Management via FRM220 chassis
10/100/1000Base-T to 1000Base-SX/LX SFP Managed card
Auto-negotiation or forced mode
Auto MDI/MDIX
Forward 1632 bytes (max.) packets
Support Bandwidth Control (70k ~ 250Mbps) pp
Supports Flow control (Pause)
Support Link fault pass through (LFP) function in Port VLAN mode
Supports remote CPE power fail detect (dying gasp)
Auto Laser Shutdown (ALS) in Switch mode
Online f/w upgrade
Panel
• Figure #1. Upper Panel of FRM220-1000E(S)-1
• Figure #2 Stand alone rear panel of FRM220 1000E(S) 1 • Figure #2 Stand-alone rear panel of FRM220-1000E(S)-1
CH01
CH01-AA CH01-DD
g
( p )
CH01-AD CH01-DC CH01-AC
CTC Union Technologies Co., LTD.
WWW . CTCU . COM
User Guide
•Gigabit Ethernet over Fiber Media Converter
•FRM220-1000E(S)-1
Specification
Standard
IEEE802.3 10Base-T, IEEE802.3u 100Base-TX, IEEE802.3ab 1000Base-T,
IEEE802.3z 1000Base-SX/LX, Gigabit Standards
10/100/1000Base-T RJ-45 Connectors
1000ES-1 : One RJ45 connector is provided for UTP cable connection
1000E-1 : One RJ45 connector is provided for UTP cable connection
All RJ45 ports utilizing auto MDI/MDIX which allow all UTP connections for both All RJ45 ports utilizing auto MDI/MDIX, which allow all UTP connections for both
straight and crossover UTP cable.
RJ-45 Pin 568-A type
5 Pair1-Tip
4 Pari1-Ring
3 Pair2-Tip
6 Pair2-Ring
1 Pair3-Tip
2 Pair3-Ring-
7 Pair4-Tip
8 8 Pair4-Ring Pair4 Ring
1000Base-X Fiber Optic Connectors
Application
1000ES-1 : One SFP slot LC connector is provided for optic cable connection
1000E-1 : One SC connector is provided for optic cable connection
Environment
Operating --0 to 60℃, Storage --0 to 70℃, Humidity -- 10 to 90%, (non-condensing
Power
Adapter: 12V DC 1A,
Built-in AC Power 100~240 V,
Built-in DC Power 18~72VDC
Dimensions:
(D x W x H) mm 155 x 88 x 23mm
568-B type
Pair1-Tip
Pair1-Ring
Pair3-Tip
Pair3-Ring
Pair2-Tip
Pair2-Ring
Pair4-Tip
Pair4-Ring Pair4 Ring
)