Ports And Cabling - Cisco 1100 Series Hardware Installation Manual

Installing and Connecting the Router
Never install telephone jacks in wet locations unless the jack is specifically designed for wet locations.
Warning
Statement 1036
Never touch uninsulated telephone wires or terminals unless the telephone line has been disconnected at
Warning
the network interface. Statement 1037
For connections outside the building where the equipment is installed, the following ports must be connected
Warning
through an approved network termination unit with integral circuit protection, LAN, PoE. Statement 1044
Avoid using or servicing any equipment that has outdoor connections during an electrical storm. There
Warning
may be a risk of electric shock from lightning. Statement 1088

Ports and Cabling

This chapter summarizes typical WAN and LAN connections for routers. The connections summarized here
are also described in detail in the document on Cisco.com: Cisco Modular Access Router Cable Specifications
Table 8: WAN and LAN Connections
Port or Connection
Ethernet
Cisco serial
Cisco Smart serial
Gigabit Ethernet SFP, optical
Gigabit Ethernet SFP, copper
2 Cable color codes are specific to Cisco cables.
3 See the Cisco Modular Access Router Cable Specifications document for information about choosing these cables.
Connection Procedures and Precautions
• Connect each WAN and LAN to the appropriate connector on the chassis.
2
Port Type, Color
RJ-45, yellow
60-pin D-sub, blue
Cisco Smart compact connector,
blue
LC, color according to optical
wavelength
RJ-45
Hardware Installation Guide for the Cisco 1100 Series Integrated Services Router
Connecting WAN and LAN Interfaces
Connection:
Ethernet hub or Ethernet switch
CSU/DSU and serial network
or equipment
CSU/DSU and serial network
or equipment
1000BASE-SX, -LX, -LH, -ZX,
-CWDM
1000BASE-T
Cable
Category 5 or higher Ethernet
Cisco serial transition cable that
matches the signaling protocol
(EIA/TIA-232, EIA/TIA-449,
V.35, X.21, or EIA-530) and the
serial port operating mode
3
(DTE or DCE).
Optical fiber as specified on
applicable data sheet
Category 5, 5e, 6 UTP
39