Commonly Used Rom Monitor Commands - Cisco 1100 Series Hardware Installation Manual

ROM Monitor Overview and Basic Procedures
0/2
0/3
R0
F0
P0
Slot
--------- ------------------- ---------------------------------------
0
R0
F0

Commonly Used ROM Monitor Commands

This table summarizes the commands commonly used in ROM Monitor. For specific instructions on using
these commands, refer to the relevant procedure in this document.
Table 9: Commonly Used ROM Monitor Commands
ROMMON Command
boot image
confreg
dev
dir
reset
set
sync
unset
Displaying the Available ROM Monitor Commands
This topic describes the available help commands for ROM Monitor mode.
Table 10: Help Commands in ROMMON
Command
help or ?
-?
C1111-LTE ok
ISR-AP1100AC-N ok
C1111-8PLTELAWN ok, active
C1111-8PLTELAWN ok, active
PWR-12V ok
CPLD Version Firmware Version
17100501 16.6(1r)RC3
17100501 16.6(1r)RC3
17100501 16.6(1r)RC3
Hardware Installation Guide for the Cisco 1100 Series Integrated Services Router
Entering ROM Monitor Mode
00:02:41
00:02:41
00:04:56
00:04:56
00:04:30
Description
Manually boots a Cisco IOS XE software image.
Changes the config-register setting.
Displays the available local storage devices.
Displays the files on a storage device.
Resets the node.
Displays the currently set ROM Monitor
environmental settings.
Saves the new ROM Monitor environmental settings.
Removes an environmental variable setting.
Description
Displays a summary of all available ROM Monitor
commands.
Displays information about command syntax.
43