Hardware Installation Guide For The Cisco 1100 Series Integrated Services Router - Cisco 1100 Series Hardware Installation Manual

Exiting ROM Monitor Mode
DETAILED STEPS
Step 1 (Optional) Run the show platform command or the show rom-monitor slot command on the router to see the current
release numbers of ROMmon on the hardware.
Step 2 If the ROMmon image has not been copied onto the router, copy the PKG file that is made available as part of this
ROMmon release onto the bootflash: or usb[0-1]: file system using the copy source-location destination-location command.
Step 3
Run the dir file-system command to verify that the ROMmon file is copied into the specified directory.
Step 4 Run the upgrade rom-monitor filename location all command to begin the ROMmon image upgrade, where location
is the path to the ROMmon file.
Do not remove hardware, turn off power, or interrupt the router in any way during the ROMmon upgrade.
Caution
Although the router should be able to recover from most interruptions during the ROMmon upgrade, certain
scenarios may cause unpredictable problems.
Step 5 Messages pertaining to the upgrade are displayed on the console. After the display of these messages stops and the router
prompt is available, run the reload command to reload the router.
Step 6
If autoboot has not been enabled by using the config-register 0x2102 command, run the boot filesystem:/file-location
command at the ROMmon prompt to boot the Cisco IOS XE image, where filesystem:/file-location is the path to the
consolidated package file. The ROMmon upgrade is not permanent for any piece of hardware until the Cisco IOS XE
image is booted.
Step 7 Run the enable command at the user prompt to enter the privileged EXEC mode after the boot is complete.
Step 8
Run the show platform command or the show rom-monitor slot command to verify whether the ROMmon has been
upgraded.

Hardware Installation Guide for the Cisco 1100 Series Integrated Services Router

48
ROM Monitor Overview and Basic Procedures