1Ge Uplink Ports And Cabling Specifications; A P P E N D I X B Cable And Connector Specifications - Cisco 7600 Series Manual

Appendix B Cable and Connector Specifications
Table B-1
Supervisor Engine or RSP
Supervisor Engine 32
Supervisor Engine 2

1GE Uplink Ports and Cabling Specifications

Table B-2
Table B-3
Note Use Category 5 Shielded Twisted Pair cable at the port that supports the10/100/1000-Mbps RJ-45
connector for the RSP720-10GE.
Table B-2
Product ID
Copper Modules
GLC-SX-MM
GLC-LH-SM
GLC-ZX-SM
GLC-T
GLC-BX-D
GLC-BX-U
Fiber Modules
OL-10100-04
Uplink Port Transceiver Modules (continued)
Transceiver Module Part Numbers
10GE Uplink Ports (WS-SUP32-10GE-3B only):
XENPAK-10GB-CX4
XENPAK-10GB-SR
XENPAK-10GB-LX4
XENPAK-10GB-LR
XENPAK-10GB-ER
1GE Uplink Ports (WS-SUP32-GE-3B):
GLC-SX-MM
GLC-LH-SM
GLC-ZX-SM
GLC-T
1000BASE-X GBIC modules, which are preinstalled
describes the 1GE SFP transceiver modules that are used for Cisco 7600 uplink ports.
provides cabling specifications.
1GE SFP Transceiver Modules
Description
1000BASE-SX SFP transceiver module for multimode fiber
(MMF), 850-nm wavelength, LC connector
1000BASE-LX/LH SFP transceiver module for MMF and
single-mode fiber (SMF), 1300-nm wavelength, LC connector
1000BASE-ZX SFP transceiver module for SMF,
1550-nm wavelength, LC connector
1000BASE-T SFP transceiver module for Category 5, 5e, or 6
copper wire; 10/100/1000-Mbps RJ-45 connector
1000BASE-BX10 SFP module for single-strand SMF,
1490-nm TX/1310-nm RX wavelength (downstream use in
bidirectional single fiber applications), with Digital Optical
Monitoring (DOM), LC connector
1000BASE-BX10 SFP module for single-strand SMF,
1310-nm TX/1490-nm RX wavelength (upstream use in
bidirectional single fiber applications), with DOM, LC connector
Cisco 7600 Series Router Supervisor Engine and Route Switch Processor Guide
Uplink Port Transceiver Modules
B-3