Cleaning The Platen; Powering On The Imager - Codonics Horizon User Manual

2. Press the
3
NOTE: Always use the
rocker switch at the back of the imager should always be in the
imager is being serviced or moved.
The control panel display shows startup messages as the imager
initializes and warms up. When the Status screen displays
(shown below), the imager is ready to receive images.
1: No cassette
2: No cassette
3: No cassette
No sheets queued
`äÉ~åáåÖ=íÜÉ=mä~íÉå
After powering on the imager for the first time, you should clean
the platen. For instructions on how to clean the platen, refer to
"Cleaning the Platen and Donor Guide Bar" on page 10-8.
(power) key at the control panel.
key at the control panel to power on/off the imager. The power
Supply
Status OK
Horizon Imager User's Manual
1
(on) position, unless the
2-11