Setting Up San Boot; Setting The Selectable Boot - Fujitsu ETERNUS DX Configuration Manual

Chapter 2 Setup Procedure for QLogic Converged Network Adapter Cards
2.2 Setting Up the Converged Network Adapter Cards
(2)
Select the Converged Network Adapter card to be set (BIOS setting) in the [Select Host Adapter]
window.
The [Fast!UTIL Options] menu appears. Then perform
11
Select [Exit Fast!UTIL] and press the [Enter] key.
12
Select [Reboot System] and press the [Enter] key.
The server reboots.
To return to the [Fast!UTIL] menu, select [Return to Fast!UTIL].
2.2.2

Setting Up SAN Boot

Refer to "Server Support Matrix" to check the support status of SAN Boot and refer to the manual of the serv-
er, OS, or the Converged Network Adapter card that is to be used.
When using a logical unit (LUN) of the ETERNUS DX storage systems as a boot disk, make sure that the LUN
has enough capacity to install the OS.
2.2.3

Setting the Selectable Boot

1
Select [Selectable Boot Settings] from the [Configuration Settings] menu and press the [Enter] key.
2
Set [Selectable Boot] to "Enabled".
3
Select a boot path (ETERNUS DX port WWN) and boot LUN#.
The boot path and boot LUN# selection window only appears when [Host Adapter BIOS] is "Enabled"
in [SAN Boot].
If [Host Adapter BIOS] is "Disabled", the boot path and boot LUN# selection window does not appear.
Instead, the window shown in
FUJITSU Storage ETERNUS DX Configuration Guide -Server Connection- (FCoE) for VMware
Exit Fast!UTIL
Reboot System
Return to Fast!UTIL
Step 4
Copyright 2015 FUJITSU LIMITED
Step 3
appears when [Selectable Boot Settings] is selected.
26
through Step 10.
®
ESX
P3AM-4772-11ENZ0