Fujitsu ETERNUS DX Configuration Manual page 3

This manual briefly explains the operations that need to be performed by the user in order to connect an
ETERNUS DX to a server running VMware
FCoE interface.
This manual is used when performing the setup procedure described in "Setting Up the VMware ESX Server"
of the "FUJITSU Storage ETERNUS DX Configuration Guide -Server Connection- (FCoE) for VMware
This manual should be used in conjunction with any other applicable user manuals, such as those for the
ETERNUS DX, server, OS, Converged Network Adapter cards, and drivers.
Refer to "FUJITSU Storage ETERNUS DX Configuration Guide -Server Connection- Notations" for the notations
used in this manual such as product trademarks and product names. For storage systems that are supported
by the OS, refer to the Server Support Matrix of the ETERNUS DX.
The Contents and Structure of this Manual
This manual is composed of the following two chapters and an appendix.
"Chapter 1 Setup Procedure for Emulex Converged Network Adapter Cards" (page 5)
•
This chapter describes how to set up the server and Emulex Converged Network Adapter card driver when
connecting the ETERNUS DX storage systems to the server via Emulex Converged Network Adapter cards.
"Chapter 2 Setup Procedure for QLogic Converged Network Adapter Cards" (page 21)
•
This chapter describes how to set up the server and QLogic Converged Network Adapter card driver when
connecting the ETERNUS DX storage systems to the server via QLogic Converged Network Adapter cards.
A WWN instance management table for the server which is used when checking the Converged Network
Adapter cards is described in the appendix.
FUJITSU Storage ETERNUS DX Configuration Guide -Server Connection- (FCoE) for VMware
®
ESX and using Emulex Converged Network Adapter cards via an
3
Copyright 2015 FUJITSU LIMITED
Preface
®
ESX".
11th Edition
June 2015
®
ESX
P3AM-4772-11ENZ0