Installing Vmware Esx - Fujitsu ETERNUS DX Configuration Manual

Chapter 2 Setup Procedure for QLogic Converged Network Adapter Cards
2.2 Setting Up the Converged Network Adapter Cards
8
Select [Reboot System] and press the [Enter] key.
The server reboots.
To return to the [Fast!UTIL] menu, select [Return to Fast!UTIL].
2.2.4

Installing VMware ESX

VMware ESX should be installed now if it has not yet been installed in the server. Refer to the following
•
URL for details.
http://www.vmware.com/support/pubs/
• If SAN Boot is used, use the QLogic "Fast!UTIL" tool to check the Fibre Channel path in the Converged Net-
work Adapter card BIOS.
The Fibre Channel path can be checked on the server BIOS screen after the Fibre Channel switch and the
CEE/FCoE switch settings are completed.
The checking procedure is as follows:
1
Turn on the server, and press the [Ctrl] + [Q] keys while the following message is displayed.
The "Fast!UTIL" program starts up (Startup may take longer than usual).
QLE8142
Copyright (C) QLogic Corporation 1993-2010. All rights reserved.
www.qlogic.com
Press <CTRL-Q> or <ALT-Q> for Fast!UTIL
Firmware Version 5.04.01
2
When there are two or more FCoE ports for the Converged Network Adapter card, select the appropriate
port.
3
Select [Scan Fibre Devices] from the [Fast!UTIL Options] menu.
The ETERNUS DX storage systems should appear.
If the ETERNUS DX storage systems appear, the settings were performed successfully. If the ETERNUS DX stor-
age systems do not appear, recheck the setup procedures given in this manual, the ETERNUSmgr installation
and settings, or the Fibre Channel switch and CEE/FCoE switch settings.
FUJITSU Storage ETERNUS DX Configuration Guide -Server Connection- (FCoE) for VMware
Exit Fast!UTIL
Reboot System
Return to Fast!UTIL
PCI Fibre Channel ROM BIOS Version 3.00 - Beta 14
Copyright 2015 FUJITSU LIMITED
28
®
ESX
P3AM-4772-11ENZ0