Fujitsu ETERNUS DX Configuration Manual page 13

Server connection, fcoe for vmware esx driver settings for non-fujitsu converged network adapter cards

Hide thumbs Also See for ETERNUS DX:

Configuration manual (85 pages)

User manual (42 pages)

User manual (35 pages)

Table Of Contents

Table of Contents

Chapter 1

Setup Procedure for Emulex Converged Network Adapter Cards

1.2

Setting Up the Converged Network Adapter Cards

Select a boot device. Input "1" for "Select a Boot Entry:"and press the [Enter] key.

-------------------------------------------------------------------------------

01:

Mem Base:

Port Name:

Vlan ID:

-------------------------------------------------------------------------------

===> 1

A list of the WWPNs and recognized LUNs (as device names) of the connected ETERNUS DX400 series is

displayed. Input the number of the device that is to be used for SAN Booting and press the [Enter] key.

Select "01" in this example.

-------------------------------------------------------------------------------

01:

Mem Base:

Port Name:

Vlan ID:

-------------------------------------------------------------------------------

00. Clear selected boot entry!!

01. DID:xxxxxx WWPN:2040000B 5D6A0012 LUN:00

-------------------------------------------------------------------------------

===> 01

Input the starting LUN as a two-digit hexadecimal number and press the [Enter] key.

Input "00" in this example.

---------------------------------------------------

Enter two digits of starting LUN (Hex):

---------------------------------------------------

===> 00 -> Enter

FUJITSU Storage ETERNUS DX Configuration Guide -Server Connection- (FCoE) for VMware

Emulex OneConnect FCoE BIOS Utility, xxxxxxxx

OCexxxxx-F:

CD4C0000

Firmware Version:

xxxxxxxx xxxxxxxx

xxxx

DCBX mode:

CEE mode

List of Saved Boot Devices:

1. Unused