16 Operation
You have "room temperature
based" control of your system
(remote controller room
thermostat is installed)
16.3
Operating the system
16.3.1
About the clock
INFORMATION
▪ The clock must be set manually. Adjust the setting
when switching from summertime to wintertime and
vice versa.
▪ The clock cannot be adjusted if the controller is set to
permission level 2 or 3 (see field setting [0‑00] in
"7.2.9 Field settings on the user interface" on
▪ A power failure of more than 2 hours will reset the clock
and the day of the week. The schedule timer will
continue operation, but with a disordered clock. Correct
the clock and the day of the week.
Installer and user reference guide
58
Select mode (heating h or cooling c)
Push bi or bj
Display: - starts to blink
Set desired room temperature
(e.g. 22°C)
Push ébi or ébj
Set desired leaving water temperature (e.g. 45°C for
heating or 18°C cooling)
If the display is blank, automatic leaving water
temperature is enabled in heating operation
Push y
The 0 LED will light up and the unit will start
For further details and advised settings, see the
chapters about programming, space cooling
operation, and space heating operation.
page 35).
Display: "n"
The remote controller room
thermostat function is not installed
You have "leaving water temperature
based" control of your system
(default)
To set the clock
1 Hold down the
button for 5 seconds.
Result: The clock read-out and the day of week indicator start
flashing.
2 Press the
or
by 1 minute. Keep the button pressed to increase/decrease the
time by 10 minutes.
3 Press the
or
next day of the week.
4 Press the
button to confirm the current set time and day of
the week.
5 Press the
button to cancel this procedure without saving.
Result: If no button is pressed for 5 minutes, the clock and day
of the week will return to their previous setting.
SERHQ020~032BAW1 + SEHVX20~64BAW
button to increase/decrease the time
button to display the previous or
Split packaged air-cooled water chiller
4P508020-1B – 2018.04
Need help?
Do you have a question about the SERHQ020BAW1 and is the answer not in the manual?