EMS iris+ Installation Manual page 26

The following example shows how to con gure Output 4 (Relay 3) to change state upon an alarm
transmission. This example could be used to operate a Piezo Sounder. Follow the steps listed below:
Access the Main Menu by following the operations listed under the previous
engineering menus
Press the
Press the
1
Press the
Press the
1
Press the
1
Press the
output to con gure: In this example, Output 4.
Note: An alternative event type can be selected from pg25.
Press the
1
Press the
1
Press the
action:
In this example, Group: 'Alarm'
Press the
1
Press the 3 key until SYSTEM RESET is displayed and turn
the keyswitch to the Clear position to exit the menu.
' section.
button until the screen displays:
button. The screen will change to display:
button until the screen displays:
button. The screen will change to display:
button. The screen will change to display:
button until the screen displays the required
button. The screen will change to display:
button once and the screen will display:
button until the screen displays the required
button. The screen will change to display:
Page 26 of 32
'Accessing the
| Radio Setup
> Output Setup
| Logging
2=Help 14:05
| ** Binary Outputs ** |
> Test Outputs
| Output Latch Times |
2=Help 14:05
| Output Permissions |
> Output On Reasons <
| Output O Reasons |
2=Help 14:05
Output On Reasons
1 = Change On Reason
3 = Exit / Finish
2=Help 14:05
| * Output on Reason * |
> 1 / 'Un-named' is
| Switched on by
2=Help 14:05
|-------------------------------- |
> 3 / 'Un-named' is
| Switched on by
2=Help 14:05
Edit on Reason
for Output 3
1 = deselect reason
2=Help 14:05
| * Select on Reason * |
> NOTHING <
|---------------------------------|
2=Help 14:05
|---------------------------------|
> Group: 'Alarm'
|---------------------------------|
2=Help 14:06
|---------------------------------|
>*REASON*SELECTED* <
| Group: 'Alarm'
2=Help 14:06
|
<
|
<
<
|
<
|
<
|