Adding A Transmitter - EMS iris+ Installation Manual

Adding a transmitter

To add any additional transmitters, access the Main Menu by following the operations listed
under the previous
Now, follow the steps listed below:
Press the
display:
Press the
1
Press the 1
(See Appendix 1 for details of transmitter options)
Use the
transmitter to be added and press the
screen will change to display the options available
(handpush screen shown):
Press the
action required and press the
change to display (handpush screen shown):
Operate the unit to generate a transmission and the
screen will display:
After a short period of time the screen will change to
display (handpush screen shown):
Using the same operation, once again generate a
transmission, after a short period of time the screen will
change to display (handpush screen shown):
You may now add additional transmitters, by repeating the above steps. If no further
transmitters are to be added, then escape from this menu by pressing the
returning the key to CLEAR.
'Accessing the engineering menus
button four times, the screen will now
button. The screen will change to display:
button. The screen will change to display:
or arrow keys to highlight the type of
or arrows to highlight the transmitter
1
' section.
button, the
1
button. The screen will
Page 17 of 32
| Time and Date
> Radio Setup
| Output Setup
2 = Help 13: 47
| ** Radio Setup ** |
> Add Transmitter
| Txer Details
2 = Help 13: 47
| Add Transmitter
> Add Handpush
| Add Moneyclip
2 = Help 13: 47
| Handpush Type
> Opposed Action
| Non-Opposed
2 = Help 13: 47
Operate Transmitter
NOW or press
Escape to cancel
13: 48
Release all buttons
NOW
13: 48
Operate Transmitter
Again or press
Escape to cancel
13: 48
Hand Push 001
Added
Push any key
13: 48
button or
3
|
<
|
<
|
|
<
|
|
<
|