Naming A Transmitter - EMS iris+ Installation Manual

Naming a transmitter

To change the name of any transmitters, access the Main Menu by following the operations
listed under the previous
Now, follow the steps listed below:
Press the
display:
Press the
1
Press the 1
Press the
1
Press the
Press the
1
Generate a transmission and the screen will change to
display:
After a short period of time the screen will display:
Once again generate a transmission, the screen will
change to display:
Note: the current selected character is shown above the
centre bar.
'Accessing the engineering menus
button four times. The screen will now
button. The screen will change to display:
button. The screen will change to display:
button. The screen will change to display:
button once. The screen will display:
button. The screen will display:
Page 18 of 32
' section.
| Time and Date
> Radio Setup
| Output Setup
2 = Help
| ** Radio Setup ** |
> Add Transmitter
| Txer Details
2 = Help
| Add Transmitter
> Txer Details
| Set Radio Rules
2 = Help
| - Txer Details -
> Name by Number <
| Name by Tx
2=Help
| Name by Number
> Name by Tx
| View Names
2=Help
Operate Transmitter
NOW or press
Escape to cancel
Release all buttons
NOW
Operate Transmitter
Again or press
Escape to cancel
|
|
4< IJKL M NOPQR
2=Help
|
<
|
13: 49
<
|
13: 49
|
<
|
13: 49
|
|
13: 49
|
<
|
13: 49
13: 50
13: 50
13: 50
|
|
>6
13: 50