MakerBot Replicator Z18 Quick Start Manual page 2

MAKERBOT ® REPLICATOR ® Z18 3D PRINTER
1. Remove packaging materials 2. Remove filament and accessory box
and protective film
NOTE: Hold on to these packaging materials in case
you need to transport your MakerBot Replicator Z18
in the future.
4. Adjust feet for stability 5. Unlock lid
7. Remove gantry clips 8. Install Smart Extruder
Caution: Two people are required to lift the MakerBot Replicator Z18. Do not lift
alone. To prevent injury, lift with your legs, not your back.
MB_Moose_QSG_v1.indd 4-5
3. Place on a low, stable surface
Note: You will need to remove the lid of the MakerBot
Replicator Z18 to complete the setup process. Make
sure you have access to the top of the printer.
6. Remove lid
9. Load filament spool
Exercise caution when accessing the top compartment, and always keep it locked
when your MakerBot Replicator Z18 is in use. It contains hot surfaces and moving parts.
10. Feed filament by hand until it 11. Rotate latches and remove build plate
emerges in top compartment
13. Replace build plate 14. Plug in and power on
16. Guide filament under extruder guard 17. Replace lid
and insert into the Smart Extruder
We Can't Wait to See What You Make!
12. Apply tape to build plate
15. Press dial and follow instructions
18. Choose a test print
5/13/14 7:57 PM