Table of Contents
Advertisement
Field Service Ver. 1.0 Jun. 2008
[2]
11. Perform another test print and check the reference deviation.
12. Repeat the adjustment until the reference line falls within the specified range.
13. Tighten the adjustment screw.
14. Touch [OK].
15. Touch [OK] on the Service Mode screen.
16. Turn OFF the main power switch, then wait for 10 sec. or more and turn ON the main
power switch.
Y109730-6
[1]
A0EPF3C506DA
[1]
A0EPF3C507DA
Service Manual
5. Machine Adjustment
9. Loosen two screws [1].
10. Watching the gradations [1] provided
in the multi bypass tray, move the
edge guide [2] position.
• If width A is greater than the specified
value, move the edge guide toward the
right.
• If width A is smaller than the specified
value, move the edge guide toward the
left.
15
Advertisement
Table of Contents
