Rikon Power Tools 10-306 Operator's Manual page 17

2. When the guide bearings are in proper position, tighten
the guidepost lock knob loosened in the previous step.
ADJUSTING THE FENCE ON THE CARRIER
The fence can be changed from a vertical position to a
horizontal position, or from its mounting on the left side
of the blade to the right with simple adjustments of the
carrier's handles and hardware.
To change the fence from vertical to horizontal:
1. Loosen the two side Knobs (#110, FIG. 31, A) which
hold the Fence (#106) against the Fence Carrier (#107, B).
2. Slide the fence forward to remove it from the carrier's
Locking Frame Bar (#105, FIG. 32, C).
3. Rotate the fence 180°, turn it down to its horizontal
position and slide it back onto the carrier. The short face of
the fence is slotted to mount on the frame bar. FIG. 33.
4. Once in place, retighten the two side knobs to secure the
fence in position on the carrier.
5. Confirm that the fence is parallel with the blade and miter
gauge slot, and make corrections for 'drift' if needed per
instructions on page 13.
To change the fence from the left side of the
carrier to the right side for using the rip fence to
the right of the blade:
1. Loosen the two side Knobs (#110, FIG. 31, A) which
hold the Fence against the Fence Carrier (#107, B).
2. Slide the fence forward to remove it from the carrier's
Locking Frame Bar (#105, FIG. 32, C). Move the carrier on
the front rail to the right side of the table and blade.
3. Fully unscrew the side knobs from the frame bar and
reassemble the parts on the opposite, left side of the
carrier. Then rotate the fence 180° end-to-end and slide it
back onto the carrier. FIG. 34 & 35.
ADJUSTMENTS
Approximately
1/4"
FIGURE 28
CONTINUED ON PAGE 18
B
FIGURE 29
PLUGGED IN AND THE POWER SWITCH MUST BE IN THE
OFF POSITION UNTIL ALL ADJUSTMENTS ARE COMPLETE.
17
A
FIGURE 30
THE MACHINE MUST NOT BE
A
B
FIGURE 31
C
FIGURE 32
FIGURE 33