Configuring The Ipdr Collector; Configuring The Ipdr Associate - Cisco cBR-8 Configuration And Troubleshooting Manual

IPDR Streaming Protocol
What to Do Next
Note Once the IPDR session type is configured, only the templates supported by this IPDR type are allowed
be associated with it. Also, the console provides information about those templates that are not supported
by this IPDR session type when the type is changed.

Configuring the IPDR Collector

To configure the IPDR collector details, use the ipdr collector command in global configuration mode. The
port number is used when an exporter creates an active connection.
DETAILED STEPS
Command or Action
Step 1 enable
Example:
Router> enable
Step 2
configure terminal
Example:
Router# configure terminal
Step 3
ipdr collector
Example:
Router(config)# ipdr collector federal
192.168.6.5

Configuring the IPDR Associate

To associate the collector with a session, use the ipdr associate command in global configuration mode.
Before You Begin
• You must deactivate the session before configuring the associate.
Cisco cBR Series Converged Broadband Routers Troubleshooting and Network Management Configuration Guide
Purpose
Enables privileged EXEC mode.
• Enter your password if prompted.
Enters global configuration mode.
Enables the CMTS application to configure an IPDR collector and
authenticate the IPDR protocol.
Configure the NAT address in case of an IPDR collector
Note
that is operating in a NAT enabled network.
Configuring the IPDR Collector
for Cisco IOS XE Fuji 16.8.x
113