Roland Metaza MPX-50 User Manual page 20

Part 2 Performing Marking
4 Press down on the workpiece gently to secure it in
place.
Pressing down forcefully may make it difficult to
remove the workpiece from the base.
Loosen the screw and press down from above with the
5
leveler.
Press down until the leveler completely touches the top
surface of the base. There is no need to use excessive
force.
While pressing down with the leveler, tighten the
6
screw.
When tightening the screw, be careful not to let the
height of the surface to be marked change.
Load the base on the machine.
7
Slowly press it in inward until it makes contact.
Press it inward securely until it makes contact. Do not
stop partway, before contact is made.
8 Close the cover.
18