Operation Panel - Roland PNC-900 Camm-1 User Manual

• Operation Panel

* The TEST key and the cursor keys
function only when the SETUP LED is
lighted, and the ROTATE key functions
only when the SETUP LED is extin-
guished.
SETUP LED
This lights up when the SETUP key is
pressed.
Cutting can be performed when this is lit.
PAUSE LED
This lights up when the PAUSE key is
pressed to pause the PNC-900.
PEN MODE LED
This lights up when the PEN MODE key is
pressed.
ROTATE LED
This lights up when the ROTATE key has
been pressed.
ORIGIN SET Key
Press this key to move and set the origin
point for cutting.
POWER/ERROR LED
This lights up when the power is switched
on, and flashes when an error is generated.
4
DESK TOP SIGN MAKER
SETUP
PAUSE
PEN MODE
ROTATE
TEST
ORIGIN SET
POWER
ERROR
SETUP Key
After the sheet has been loaded, press this
key to determine the width of the sheet
automatically. Also, pressing this key after
using the PAUSE key to temporarily stop a
cutting operation in progress thereby
deletes the data that has been sent to the
PNC-900 from the computer.
PAUSE Key
When pressed once, this temporarily halts
cutting in progress. Pressing this key again
releases the paused state.
PEN MODE Key
Press this to perform plotting with a pen on
paper. (Be sure to load a pen in the tool
carriage.)
ROTATE Key
Pressing this key sets the origin point at the
bottom right of the sheet and rotates the
direction of cutting by 90 .
TEST Key
Pressing this key executes a cutting test,
allowing confirmation of the suitability of
the pressure for the blade.
(Cursor Keys)
Use these keys when moving the tool
carriage for setting the origin or performing
a cutting test.
The direction of the arrows on the
, and keys indicates the direction in
which the tool carriage moves in relation to
the sheet. Pressing the key, for
example, moves the tool carriage to the
left, and pressing the key moves it to
the right. However, pressing the
key does not actually cause the tool
carriage to move -- instead, the sheet
moves. This means that pressing the
causes the sheet to move toward the front
of the machine, and pressing the
makes the sheet move to the rear.
, ,
or
key