Frequency References (Control Panel: Menu Par -> P3) - Honeywell SmartVFD COMPACT User Manual

62
2.5 L
OCAL
This parameter defines whether the control place of the drive is remote (I/O or
FieldBus) or Keypad. Keypad can also be selected as control place by press-
ing the navigation wheel for 5 seconds.
The priority order of selecting control place is
10.3 FREQUENCY REFERENCES (CONTROL PANEL: MENU PAR -> P3)
3.3 I/O
Defines the selected frequency reference source when the drive is controlled
from the I/O terminal.
3.4 - 3.11 P
These parameters can be used to determine frequency references that are ap-
plied when appropriate combinations of digital inputs are activated. Preset
speeds can be activated from digital inputs despite of the active control place.
Parameter values are automatically limited between the minimum and maxi-
mum frequencies. (par. 3.1, 3.2).
If P3.3 = 0,
Preset speed 0
Preset speed 1
Preset speed 2
Preset speed 3
Preset speed 4
Preset speed 5
Preset speed 6
Preset speed 7
Table 10.1: Preset speeds 1 - 7
10
Parameter Descriptions
/R
EMOTE
1. Navigation wheel
2. Forced from I/O
3. Parameter 2.1
REFERENCE
0 = Preset speed 0 - 7
1 = Keypad reference
2 = Reference from Fieldbus (FBSpeedReference)
API FULL & LIMITED:
3 = AI1 reference (terminals 2 and 3, e.g. potentiometer)
API FULL:
4 = AI2 reference (terminal 4 and 5, e.g. transducer)
0 - 7
RESET SPEEDS
Speed Preset speed B2 Preset speed B1 Preset speed B0
x
x
x
x
x x
x x
Honeywell
x
x
x
x