Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Trotec T660
Summary of Contents for Trotec T660
- Page 1 T660 OPERATING MANUAL MOISTURE MEASURING DEVICE...
-
Page 2: Table Of Contents
Keep all safety signs, stickers and labels in legible Information marked with this symbol indicates that the condition. operating manual must be observed. • Do not open the device. • Observe the storage and operating conditions as given in the Technical data chapter. moisture measuring device T660... -
Page 3: Information About The Device
Device description materials. Observe and comply with the technical data. The material moisture measuring device T660 is a dielectric To use the device for its intended use, only use accessories and moisture indicator, which can be used for the quick and non- spare parts which have been approved by Trotec. - Page 4 • 1 x Display protection film • 1 x USB cable Designation CFG symbol (configuration mode display) Measuring mode Measurement value display top Indication of the unit (moisture in % or CM) Measurement value display bottom Configuration mode moisture measuring device T660...
-
Page 5: Transport And Storage
Make sure that the surface of the device is dry and the device is switched off. 1. Remove the battery compartment cover (3). 2. Insert the batteries with correct polarity. 3. Insert the battery compartment cover (3). ð The device can now be switched on. moisture measuring device T660... - Page 6 5. Carry out further measurements at the component. Higher measured values usually signify a higher moisture content in the near-surface area of the material to be measured. moisture measuring device T660...
- Page 7 Here you can select the construction material for the measurement. The following options are available: • 0 no: No material selected. • 1 An: The selected material is anhydrite screed. • 2 CE: The selected material is cementitious screed. moisture measuring device T660...
- Page 8 ð All previously stored measured values of the measuring modes AVG, MIN, MAX and HOLD will be set back. ð All previously stored measured values of the measuring modes AVG, MIN, MAX and HOLD will be set back. moisture measuring device T660...
-
Page 9: Measuring Principle
Therefore, this method is well suited for the examination of water damage, leak detection and the localization of moisture zones for the purpose of marking the measuring spot for CM measurements. moisture measuring device T660... -
Page 10: Pc Software
® the device when using this PC software and a TROTEC below. dongle (professional). This graph was created in collaboration with the Institute of... -
Page 11: Maintenance And Repair
Batt lo is displayed upon detected by the operating system. switch-on. ® If you only connect the TROTEC USB dongle (Professional) • Check that the batteries are properly positioned. Check the to your PC after starting the PC software, click the polarity is correct. -
Page 12: Disposal
For further return options provided by us please refer to our website https://de.trotec.com/shop/. The separate collection of waste electrical and electronic equipment aims to enable the re-use, recycling and other forms... - Page 13 Trotec GmbH Grebbener Str. 7 D-52525 Heinsberg +49 2452 962-400 +49 2452 962-200 info@trotec.com www.trotec.com...