Raymarine SPX-5 Installation & Setup Manual page 47

Chapter 3: Commissioning & setup
Carry out an AutoLearn as follows:
1. Ensure you have sufficient sea room to complete the AutoLearn:
2. Access the AUTOLEARN screen in Seatrial calibration:
From Standby mode, hold down standby for 2 seconds, then press disp twice
i.
to see the SEATRIAL CAL screen.
ii. Press auto to enter Seatrial calibration, then press disp four times to see the
AUTOLEARN screen.
3. Prepare to start the AutoLearn:
• Steer straight ahead (rudder centered) and motor the boat at typical cruising
speed.
• If conditions are not calm, head into the wind and waves.
4. When you are ready to start the AutoLearn, press +1 then auto.
Enter Seatrial calibration
Prepare for AutoLearn
• steer straight ahead at cruising speed
(planing boats – just on the plane)
• head into wind and waves
2 sec
x4
CHECK!
Before proceeding, ensure
you have sufficient clear
sea space
1 minute
(approximately)
x2
AutoLearn in progress
Start
AutoLearn
39
D10544-1
D10545-1