Raymarine SPX-5 Installation & Setup Manual page 26

18
6. Remove the wheel, then hold the bracket on the pedestal in the location you have
marked.
7. Check the position and alignment of the pedestal bracket:
• the bracket pin should be aligned so it is directly below the pedestal spindle
154 mm
(6.1 in)
8. When the pedestal bracket is correctly positioned and aligned, mark around the
inside of the slots, then remove the bracket.
9. Use a center-punch to mark the center of each slot, then use the smaller supplied
drill bit to drill a 4.0 mm (
Note:
Drill at right angles to the pedestal surface.
SmartPilot X-5 Wheel Installation & Setup Guide
5
/ in) diameter hole.
32