Commissioning Complete - Raymarine SPX-5 Installation & Setup Manual

40
5. The screen will show the CLEAR TO MANEUVER message. Ensure it is safe to
continue, then press auto to start the AutoLearn maneuvers:
• The boat will start a series of zig-zag turns and the display will show LEARNING
with a number to indicate the current AutoLearn stage. This number increases
as AutoLearn progresses.
• A typical AutoLearn completes within 7 to 27 steps (depending on boat
characteristics and sea conditions).
Note:
To cancel an AutoLearn, press standby or disp.
6. When the SPX-5 Wheel system has finished learning, the controller will beep and
display either LRN PASS or LRN FAIL:
• LRN PASS = AutoLearn completed successfully
• LRN FAIL = AutoLearn was not successful, so should be repeated. A failure
code will also be displayed:
1 = AutoLearn has not been carried out.
2 = AutoLearn failed, due to manual interruption.
4 = AutoLearn failed, probably due to drive or compass failure.
5 = AutoLearn failed, probably due to motor current limiting.
6 = AutoLearn failed, probably due to boat spinning.
7. If the AutoLearn was successful, hold down standby for 2 seconds to store the
new settings.
Boat completes AutoLearn
!
If you need to cancel the AutoLearn, press
Save new settings

Commissioning complete

Your SPX-5 Wheel system is now commissioned and ready for use.
After having used your SPX-5 Wheel system, you may decide to change the value of
some parameters to improve pilot performance with your boat. If you feel this is
necessary, use the appropriate procedures under Manual setup , below.
SmartPilot X-5 Wheel Installation & Setup Guide
AutoLearn successful
After
7 to 27
steps
2 sec
Note: If you see a
LRN FAIL message,
press disp to return to
the AUTOLEARN screen
then repeat from Step 2
or
To:
• save AutoLearn calibration settings
• return to STANDBY mode
D10546-1