Table of Contents
Advertisement
Tools and materials for mounting
Name
Electric drill
Hexagonal wrench
Self-vulcanizing tape
Vinyl tape
Cable tie
Marine sealant
Installation on a platform
Follow the instructions below to install the sensor on a platform.
Power/LAN cable (1.4 m)
Mounting platform
Drill holes referring to the outline drawing
and the mounting template.
Default orientation of
bolt and flat washer
Note: On the bolt and washers,
• DO NOT detach the hex bolts and flat washers until the installation.
• DO NOT turn the radome upside down after detaching the hex bolts and flat wash-
ers.
• If the radome is put upside down with only the small flat washer and hex bolt in
place, the hex bolt and flat washer may protrude into the radome and damage the
RT unit.
Drill holes for mounting. Drill bit: 11 mm
Fastening bolts: Diagonal: 6 mm
For water proofing of connector junction.
For tying up the cable.
For coating exposed parts of bolts.
STERN
3
1. INSTALLATION
Usage
BOW
Align bow mark (Δ)
on antenna with
boat's centerline.
Flat washer
Spring washer
Hex bolt (M10 × **)
**: Bolt length.
See table on next page
for details.
Flat washer (M12), top in order
For transportation, not for the
installation.
Flat washer (M10),
middle in order
Spring washer (large),
last in order.
Advertisement
Table of Contents
