Table of Contents
Advertisement
• All washers are in place and bolts are fully tightened.
• All connections are secure.
• All connecting cables and wires are secured.
• LAN cable is connected to the multi function display device.
Turning the power on and initial setup
Use the information in this manual and the manual for TZTL12F/TZTL15F/TZT9/
TZT14/TZTBB* to power the sensor and to proceed with initial setup.
* Hereafter these units are referred to as "multi function display device".
1. Press and hold down the power key of your multi function display device until the
unit is ON. The magnetron warm-up sequence starts. When the warm-up se-
quence is completed, the unit goes into the standby mode.
Note: Power is supplied to the antenna unit even when the power is shut off at the
display unit. If the radar is not to be used for an extended period, shut off the radar
from the switchboard.
2. Ensure that all personnel are clear of antenna.
3. Take the appropriate action on your multi function display device to turn on the
DRS4DL+.
4. If necessary, adjust the brightness and change the language on the multi function
display device.
5. Check if the heading is correctly aligned - targets should appear at their correct
bearing relative to the boat's bow. Adjust the alignment if necessary, referring to
installation manual of your multi function display device.
6. Check the display timing, referring to installation manual of your multi function dis-
play device.
WARNING
The radar antenna emits electro-
magnetic radio frequency (RF)
energy, which can be harmful to the
human body and interfere with pace-
maker function. Never look directly
into the antenna aperture and keep
at least 85 cm away from the radar
antenna while the radar is in operation.
13
2. INITIAL SETUP
Advertisement
Table of Contents
