Table of Contents
Advertisement
2. INITIAL SETUP
4. Select [Radar Source] on the [Menu Radar] sub menus, then select the radar type
connected.
Note: If the antenna unit is connect-
ed but does not appear in the [Ra-
dar Source] list, close the list and
open it again. The name of the an-
tenna unit should appear with a
check mark, as in the example to
the right.
5. Drag the [Menu Radar] sub menus
to find the menu item [Radar Initial
Setup].
Title
6. Set the items referring to the table shown below.
Menu item
[Antenna Rotation]
[Antenna Heading Align]
[Main Bang Suppression]
[Enable Sector Blanking]/
[Enable Sector Blanking2]
[Antenna Height]
Menu Radar (Radar Initial Setup)
Select the antenna rotation speed from [Auto] or [24 RPM].
The default setting is [Auto].
See "How to align the antenna heading" on page 9.
If main bang appears at the screen center, slide the circle
icon, while watching the radar echo on the left-side of the
display, until the main bang disappears.
Up to two sectors may be selected for blanking (no trans-
mission). Select [ON] to enable this feature. Set the start
and end angles (0° to 359°).
Select the height of the antenna above the waterline from
[Under 3 m], [3 m - 10 m] or [Over 10 m].
8
RDxxxxxx - DRS4DL+
RDxxxxxx - DRS4DL+
Display example for DRS4DL+
Description
Advertisement
Table of Contents
