Table of Contents
Advertisement
1. INSTALLATION
Note 1: The antenna unit has no power switch. Connect the antenna unit to a dis-
tribution switchboard with a switch for power control.
Note 2: The antenna unit cannot accept input voltage of more than 24 VDC.
Installation with the radome mount
The optional radome mount lets you install the radar sensor to a mast on a sailboat.
Name, Type: Radome Mount, OP03-209
Code No.: 001-078-350
Mounting plate
Support plate (1)
Support plate (2)
Bracket (1)
Bracket (2)
Fixing plate
Hex bolt w/washer
Hex bolt w/washer
How to assemble the bracket
1. Fasten the fixing plates to brackets (1) and (2) with four M8 20 hex bolts.
2. Fit brackets (1) and (2) loosely with support plates (1) and (2) using four M4 12
hex bolts, so that the gap between the brackets can be adjusted.
3. Place the mounting plate on the bracket and fix it loosely with four M8 20 hex
bolts.
Step (1)
Fixing plate
M8×20
Bracket (2)
How to fasten the bracket to the mast
1. Drill eight holes of 6.5 mm diameter in the mast.
Fasten the bracket to the mast with eight stainless
steel rivets (local supply) whose diameter is 6.4 mm.
2. Tighten the bolts on the bracket.
3. Fasten the antenna unit to the bracket with bolts
(M10
Name
03-018-9001-0
03-018-9005-0
03-018-9006-0
03-028-9101-2
03-028-9102-2
03-028-9103-2
M8 20 SUS304
M4 12 SUS304
M8×20
Bracket (1)
Bracket (2)
25).
Type
100-206-740-10
100-206-780-10
100-206-790-10
100-206-812-10
100-206-822-10
100-206-832-10
000-162-955-10
000-162-956-10
Step (2)
Bracket (1)
M4×12
M4×12
6
Code No.
Qty
Step (3)
M8×20
Mounting
plate
Rivet
M10×25
1
1
1
1
1
2
10
4
Advertisement
Table of Contents
