Adjusting The Effect Settings - Roland 5100011346 -01 Owner's Manual

Using the SD-50 as a MIDI Sound Module

Adjusting the Effect Settings

Here's how to adjust the effect settings and other settings of the studio set.
1.
Press the [PART] button a number of times to access the Studio Set Edit screen.
page_studio_edit.eps
2.
Turn the [VALUE] dial to select the item you want to edit, and then press the [ENTER] button.
page_studio_edit-2.eps
Setting
Rev Type
Rev Time
Cho mode
When "CHORUS" has been selected for "Cho mode."
Cho Type
Cho Rate
Cho Depth
Feedback
Rev Send
When "DELAY" has been selected for "Cho mode."
Dly Time
Dly FB
Dly HF DMP
52
Value Explanation
SMALL ROOM, MEDIUM ROOM, LARGE ROOM:
Reverb simulating the acoustics of a room, producing a crisp and spacious
SMALL ROOM,
reverberation.
MEDIUM ROOM,
LARGE ROOM,
MEDIUM HALL, LARGE HALL:
MEDIUM HALL,
Reverb simulating the acoustics of a hall, producing reverberation with more space
LARGE HALL,
than Room.
PLATE
PLATE: Simulation of a plate reverb unit (a device using the vibration of a metal plate).
0–127 Adjusts the duration of the reverb. Higher settings produce longer reverb.
CHORUS, DELAY Selects either Chorus or Reverb.
CHORUS1, CHORUS2, CHORUS3, CHORUS4:
Typical chorus effect, adding depth and spaciousness to the sound.
CHORUS1, CHORUS2,
CHORUS3, CHORUS4,
FB CHORUS: Chorus effect that produces a soft, flanger-like sound.
FB CHORUS, FLANGER
FLANGER: Produces a sound that's reminiscent of a jet airplane taking off and landing.
0–127 Chorus with feedback applied to it.
0–127 Adjusts the rate of modulation.
0–127 Adjusts the depth of modulation.
0–127 Adjusts the amount of chorus sound to be fed back into the input.
Adjusts the amount of time it is to take for the delay sound to be heard after the
0–1000 ms, note
original sound has sounded.
Adjusts the proportion of the delay sound to be fed back to the input. (Minus:
-98– +98 %
reversed phase)
Adjusts the frequency at which the high-frequency components of the delay sound
200– 8000 Hz, BYPASS
fed back to the input will be cut. (BYPASS: no cut)