Quick Strain Filtering; Non-Auto Filter Models; Auto Filter Models - Pitco SSHLV14 Installation & Operation Manual

INSTALLATION & OPERATIONAL SSHLV MANUAL

QUICK STRAIN FILTERING

7.
When the controller indicates the need to perform a "Quick Filtering" as soon as business levels permit.
For more thorough filtering/cleaning operations refer to the Preventative maintenance section of this
document or the separate controller manual that was provided with your appliance.
7.1.

NON-AUTO Filter models

WARNING: Before filtering ensure that filter pan is in place and empty. Wear proper personal
protective equipment while filtering.
1. With Fryer ON and oil above the filter temperature, Pull the BLUE drain handle to initiate filter
prompting on the control. The controller will display 'FILTER?'
2. PRESS the 'YES' key, then press the TANK FILL key
3. Follow the store procedures for cleaning and wait for the filter timer to end.
4. When filter timer ends, push the blue handle back in to close drain. The pump will refill the fry tank.
5. When bubbles appear in oil, press the TANK FILL key
6. FILTER ONLY ONE TANK AT A TIME, the filter pan may overflow.
7.2

AUTO FILTER MODELS

WARNING: Before filtering ensure that filter pan is in place and empty. Wear proper personal
protective equipment while filtering.
1. Ensure that oil temperature is above Filter Temperature. Press the Filter button
on the controller to initiate auto-filter prompting.
2. PRESS 'YES' key to begin auto-filter process and follow the prompts on the controller to
continue the auto filter process.
3. Wait until the auto filter process completes.
4. When prompted by the controller, verify that the oil in the frypot has reached an appropriate
level. If the filter pan is empty, press the 'YES' key to complete the filter process. If there is still
oil in the filter pan, press the 'NO' key to run the pump for an additional 20 seconds.
NOTE: 'NO' may be selected for 'Is vat full' a maximum of three times. The fourth time that 'NO' is
selected the fryer will turn OFF and display 'POSSIBLE FILTER ISSUE – CHECK AND
RESOLVE'. Press the 'YES' key to acknowledge.
20
L20-407 rev.4 (011/16)
to turn pump ON.
to turn pump to OFF.