Table of Contents
Advertisement
1
.
5
.
5
C
o
n
f
i
g
u
r
i
n
g
1
.
5
.
5
C
o
n
f
i
g
u
r
i
n
g
Users can monitor and configure the switch through the following procedures.
Configuring the Management Agent of VigorSwitch P1100 through the Ethernet Port.
There are two ways to configure and monitor the switch through the switch's Ethernet port.
They are Web browser and SNMP manager. We just introduce the first type of
management interface. Web-based UI for the switch is an interface in a highly friendly
way.
Managing VigorSwitch P1100 through Ethernet Port
Before start using the switch, the IP address setting of the switch should be done, then
perform the following steps:
1.
Set up a physical path between the configured the switch and a PC by a qualified UTP
Cat. 5 cable with RJ-45 connector.
Note: If PC directly connects to the switch, you have to setup the same subnet mask
between them. But, subnet mask may be different for the PC in the remote site.
Please refer to the above figure about the 24-Port GbE Web Smart Switch default IP
address information.
2.
Run web browser and follow the menu. Please refer to Chapter 3
t
h
e
M
a
n
a
g
e
m
e
n
t
t
h
e
M
a
n
a
g
e
m
e
n
t
A
g
e
n
t
o
f
S
w
i
t
c
h
A
g
e
n
t
o
f
S
w
i
t
c
h
8
.
VigorSwitch P1100 User's Guide
- Quick Links:
- Web Management Home Overview
Hide quick links:
Advertisement
Table of Contents
