Impact Absorbing Chest Pads - Britax ADVOCATE CLICKTIGHT User Manual

Britax Child Safety, Inc.
4. Pull the end of the belly
pad and buckle retainer
out of the slot in the seat
cover to remove.
5. Turn the buckle retainer
sideways and route the
buckle assembly out of
the belly pad.
Replacing the Harness Buckle
1. Turn the buckle retainer
sideways and route it
through the fabric strip on
the belly pad.
2. Route the belly pad and
buckle retainer through
the buckle slot in the
cover.
– Ensure that the buckle
is through the correct
cover slot for the
desired buckle position.
3. Slide the end of the belly
pad over the seat and
(if applicable) over the
comfort foam.
4. Turn the buckle
retainer sideways
and route it into the
corresponding buckle
slot in the seat.
– Ensure that the
buckle is in the
correct position
and the red release
button faces out.
40
ADVOCATE/BOULEVARD CLICKTIGHT User Guide
5. Replace the cover,
ensuring the seat cover
is tucked behind the
CLICKTIGHT bar, then
close the CLICKTIGHT.

Impact Absorbing Chest Pads

IMPORTANT: Impact absorbing chest pads are highly
recommended for forward-facing mode. Removal of chest
pads is optional for rear-facing mode to ensure a snug fit
for small infants.
Removing the Impact Absorbing Chest Pads
1. Loosen the harness.
a. Press harness
release button.
b. Pull both harness
straps forward.
2. Adjust the harness to
the lowest position and
unhook the harness
straps from the yoke at
the back of the child seat.
3. Pull one harness strap
through the harness slot
to the front of the seat.
4. Route the harness strap
out of the comfort pad,
chest pad, and the chest
clip.
5. Reroute the harness strap
back through the chest
clip and comfort pad,
ensuring that the harness
strap is not twisted.
6. Repeat for other strap.
7. Route the harness straps
through the seat to the
back. Ensure that the
harness straps pass over
the tube.
1b
1a
TUBE
41